ALPS Manufacturer of Electronic Components/Parts Catalog

Knob Operating Type with Knob RK10J/RK14J Series

Detail

Part number

RK14J12R0A01

Number of resistor elements	Dual-unit
Total resistance	10kΩ
Resistance taper	15A
Soldering	Reflow
Type	14mm Size
Knob types	Outer size: φ15 Knob thickness: t0.9mm Color: Black
Mounting board types	Surface mounting
For DC use	Not applicable
Minimum order unit (pcs.)	3,000

Operating temperature range		-25℃ to +70℃
Electrical Performance	Total resistance tolerance	±30%
	Rated power	0.03W
	Maximum operating voltage	50V AC
	Maximum attenuation	70dB min.
	Insulation resistance	100MΩ min. 100V DC
	Voltage proof	100V AC for 1 minute
Mechanical Performance	Total rotational angle	270±5°
	Stopper strength	70mN·m
	Push-pull strength	5N max.
	Vibration	10 to 55 to 10Hz/min., the amplitude is 1.5mm for all the frequencies, in the 3 direction of X, Y and Z and for 2 hours respectively
Solder heat resistance	Manual soldering	350℃ max. 3s max.
	Reflow soldering	Refer to the soldering conditions
Durability	Operating life	10,000 cycles
Environmental test	Cold	-25±2℃ for 240h
	Dry heat	70±2℃ for 240h
	Damp heat	40±2℃, 90 to 95%RH for 96h

3D CAD (STEP)
Certificate of Compliance to RoHS regulations

Photo

Dimensions

Mounting Hole Dimensions

Terminal Layout

Circuit Diagram

Packing Specifications

Taping

Number of packages (pcs.)	1 reel	1,000
	1 case / Japan	3,000
	1 case / export packing	3,000
Tape width (mm)		24
Export package measurements (mm)		397×401×139

Soldering Conditions

1. Recommended reflow conditions

2. Cleaning Cleaning should not be attempted.

3. Type of solder to be used Use cream solder that contains 10 - 15 %wt flux.

4. Soldering Mounting plate should also be soldered.

(1) When using an infrared reflow oven, solder may sometimes not be applied. Be sure to use a hot air reflow oven or a type that uses infrared rays in combination with hot air.

(2) The temperatures given above are the maximum temperatures at the terminals of the potentiometer when employing a hot air reflow method. The temperature of the PC board and the surface temperature of the potentiometer may vary greatly depending on the PC board material, its size and thickness. Ensure that the surface temperature of the potentiometer does not rise to 250° or greater.

(3) Conditions vary to some extent depending on the type of reflow bath used. Be sure to give due consideration to this prior to use.

Notes are common to this series/models.

This site catalog shows only outline specifications. When using the products, please obtain formal specifications for supply. Please place purchase orders per minimum order unit (integer). Products other than those listed in above products are also available. Please contact us for details. Dip soldering can be applied to RK14J. For dip soldering applications, specify separately as "dip soldering applicable product".

Inquiries about Products For more information please contact: Products Information Center. 1-7, Yukigaya-otsukamachi, Ota-ku, Tokyo, 145-8501, Japan Phone: +81 (3) 5499-8154