Part number RK10J11R001Y
Number of resistor elements Single-unit
Total resistance 10kΩ
Resistance taper 15A
Soldering Reflow
Type 10mm Size
Knob types Outer size: φ14
Knob thickness: t1.0mm
Color: Black
Mounting board types Surface mounting
For DC use 20V DC
Operating temperature range -10℃ to +60℃
Electrical Performance Total resistance tolerance ±30%
Rated power 0.03W
Maximum operating voltage 50V AC
20V DC
Maximum attenuation 70dB min.
Insulation resistance 100MΩ min. 100V DC
Voltage proof 100V AC for 1 minute
Mechanical Performance Total rotational angle 270±10°
Rotational torque 0.5 to 10mN・m
Stopper strength 70mN·m
Push-pull strength 5N
Durability Operating life 10,000 cycles
Minimum order unit (pcs.) Japan 3,000
Export 3,000
 

Photo

Rotary Potentiometer

Dimensions

Rotary Potentiometer

Mounting Hole Dimensions

Rotary Potentiometer
 
Viewed from mounting side.

Terminal Layout

Rotary Potentiometer

Circuit Diagram

Rotary Potentiometer

Packing Specifications

Taping

Number of packages (pcs.) 1 reel 1,000
1 case / Japan 3,000
1 case / export packing 3,000
Tape width (mm) 24
Export package measurements (mm) 397×401×139

Soldering Conditions

Example of Reflow Soldering Condition
1. Heating method
Double heating method with infrared heater.
2. Temperature measurement
Thermocouple 0.1 to 0.2 Φ CA (K) or CC (T) at soldering portion (copper foil surface). A heat resisting tape should be used for fixed measurement.
3. Temperature profile
ABCDEFGHNo. of reflows
250℃200℃150℃150℃2 min.3s40s4 min.2 time max.

1. When using an infrared refl ow oven, solder may sometimes not be applied. Be sure to use a hot air refl ow oven or a type that uses infrared rays in combination with hot air.
2. The temperatures given above are the maximum temperatures at the terminals of the potentiometer when employing a hot air reflow method. The temperature of the PC board and the surface temperature of the potentiometer may vary greatly depending on the PC board material, its size and thickness. Ensure that the surface temperature of the potentiometer does not rise to 250°C or greater.
3. Conditions vary to some extent depending on the type of refl ow bath used. Be sure to give due consideration to this prior to use.

Reference for Hand Soldering
Tip temperature350℃ max.
Soldering time3s max.
No. of solders1 time


Notes are common to this series/models.

  1. This site catalog shows only outline specifications. When using the products, please obtain formal specifications for supply.
  2. Please place purchase orders per minimum order unit (integer).
  3. Products other than those listed in above products are also available. Please contact us for details.
  4. Dip soldering can be applied to RK14J. For dip soldering applications, specify separately as "dip soldering applicable product".