Number of operating shafts Single-shaft
Shaft material Resin
Actuator configuration Standard type
Mounting knob integrated
Push-on switch With
Operating force Lever portion 0.65±0.3N
Push portion 2±1N
Travel (Center push) Refer to the dimensions
Lever color of operating section Black
Location lug With
Operating temperature range -40℃ to +85℃
Ratings (max.)/(min.) (Resistive load) 10mA 5V DC/50µA 3V DC
Electrical performance Output voltage 1V max. at 1mA 5V DC (Resistive load)
Directional resolution 2-direction
Insulation resistance 100MΩ min. 100V DC
Voltage proof 100V AC for 1 minute
Mechanical performance Terminal strength 3N for 1 minute
Actuator strength Push/pull directions 50N
Operating direction 10N
Durability Operating life without load 100,000 cycles
Operating life with load (Load: as ratings) 100,000 cycles (10mA 5V DC)
Environmental performance Cold -40±2℃ for 96h
Dry heat 85±2℃ for 96h
Damp heat 40±2℃, 90 to 95%RH for 96h
Minimum order unit (pcs.) Japan 1,350
Export 5,400
 

Dimensions

Switch Type Multi Control Device

Land Dimensions

Switch Type Multi Control Device
 
Viewed from mounting face.

Circuit Diagram

Switch Type Multi Control Device
 
Push portion.

Code Table

Switch Type Multi Control Device

Packing Specifications

Taping

Number of packages (pcs.) 1 reel 1,350
1 case / Japan 2,700
1 case / export packing 5,400
Tape width (mm) 24
Export package measurements (mm) 428×413×172

Soldering Condition

Example of Reflow Soldering Condition
1. Heating method:
Double heating method with infrared heater.
2. Temperature measurement:
Thermocouple 0.1 to 0.2 Φ CA (K) or CC (T) at solder joints (copper foil surface). A heat resisting tape should be used to fix thermocouple.
3. Temperature profile
ABCDEFGHINo. of reflows
260℃230℃180℃150℃2 min.--40s-1 time

(1) The condition mentioned above is the temperature on the mounting surface of a PC board. There are cases where the PC board's temperature greatly differs from that of the switch, depending on the PC board's material, size, thickness, etc. The above-stated conditions shall also apply to switch surface temperatures.
(2) Soldering conditions differ depending on reflow soldering machines. Prior verification of soldering condition is highly recommended.

Reference for Hand Soldering
Tip temperature350±5℃
Soldering time3s max.
No. of solders1 time


Notes are common to this series/models.

  1. This site catalog shows only outline specifications. When using the products, please obtain formal specifications for supply.
  2. Please place purchase orders for taping products per minimum order unit (1 reel or a case).
  3. Products other than those listed in the above chart are also available. Please contact us for details.
  4. Please contact us for automotive use products.